19
QUESTION 5
A network administrator is explaining VTP configuration to a new technician. What should the network administrator tell the new technician about VTP configuration? (Choose three.)
A. A switch in the VTP client mode cannot update its local VLAN database.
B. A trunk link must be configured between the switches to forward VTP updates.
C. A switch in the VTP server mode can update a switch in the VTP transparent mode.
D. A switch in the VTP transparent mode will forward updates that it receives to other switches.
E. A switch in the VTP server mode only updates switches in the VTP client mode that have a higher VTP
revision number.
F. A switch in the VTP server mode will update switches in the VTP client mode regardless of the configured
VTP domain membership.
Answer: ABD
Section: Chapter 10: VLAN
Explanation/Reference:
QUESTION 6
Which two locations can be configured as a source for the IOS image in the boot system command? (Choose two.)
A. RAM
B. NVRAM
C. flash memory D. HTTP server E. TFTP server F. Telnet server
Answer: CE
Section: Chapter 5: Managing Cisco IOS
Explanation/Reference:
QUESTION 7
What are two reasons a network administrator would use CDP? (Choose two.)
A. to verify the type of cable interconnecting two devices
B. to determine the status of network services on a remote device
C. to obtain VLAN information from directly connected switches
D. to verify Layer 2 connectivity between two devices when Layer 3 fails
E. to obtain the IP address of a connected device in order to telnet to the device
F. to determine the status of the routing protocols between directly connected routers
Answer: DE
Section: Chapter 5: Managing Cisco IOS
Explanation/Reference:
QUESTION 8
Refer to the exhibit. Both switches are using a default configuration. Which two destination addresses will host 4 use to send data to host 1? (Choose two.)
A. the IP address of host 1
B. the IP address of host 4
C. the MAC address of host 1
D. the MAC address of host 4
E. the MAC address of the Fa0/0 interface of the R1 router
F. the MAC address of the Fa0/1 interface of the R1 router
Answer: AF
Section: Chapter 2: TCP/IP
Explanation/Reference:
0 Response to "19"
Post a Comment