12
QUESTION 60
Which term describes the process of encapsulating IPv6 packets inside IPv4 packets?
A. tunneling
B. hashing
C. routing
D. NAT
Answer: A
Section: Chapter 13: IPv6
Explanation/Reference:
QUESTION 61
Which statement about RIPng is true?
A. RIPng allows for routes with up to 30 hops.
B. RIPng is enabled on each interface separately. C. RIPng uses broadcasts to exchange routes.
D. There can be only one RIPng process per router.
Answer: B
Section: Chapter 13: IPv6
Explanation/Reference:
QUESTION 62
Which statement about IPv6 is true?
A. Addresses are not hierarchical and are assigned at random. B. Only one IPv6 address can exist on a given interface.
C. There are 2.7 billion addresses available.
D. Broadcasts have been eliminated and replaced with multicasts.
Answer: D
Section: Chapter 13: IPv6
Explanation/Reference:
QUESTION 63
Which line from the output of the show ip interface command indicates a layer 1 problem?
A. Serial0/1 is up, line protocol is down
B. Serial0/1 is down, line protocol is down
C. Serial0/1 is up, line protocol is up
D. Serial0/1 is administratively down, line protocol is down
Answer: B
Section: Chapter 4: Introduction to Cisco IOS
A network admin wants to know every hop the packets take when he accesses cisco.com. Which command is the most appropriate to use?
A. path cisco.com
B. debug cisco.com
C. trace cisco.com
D. traceroute cisco.com
Answer: D
Section: Chapter 2: TCP/IP
Explanation/Reference:
QUESTION 65
QoS policies are applied on the switches of a LAN. Which type of command will show the effects of the policy in real time?
A. show command
B. debug command
C. configuration command
D. rommon command
Answer: B
Section: Chapter 9: Switching
Explanation/Reference:
QUESTION 66
Which command will show the MAC addresses of stations connected to switch ports?
A. show mac-address
B. show arp
C. show table
D. show switchport
Answer: B
Section: Chapter 4: Introduction to Cisco IOS
Explanation/Reference:
QUESTION 67
What is the name of the VTP mode of operation that enables a switch to forward only VTP
advertisements while still permitting the editing of local VLAN information?
A. server
B. client
C. tunnel
D. transparent
Answer: D
Section: Chapter 10: VLAN
Explanation/Reference:
QUESTION 68
Which port state is introduced by Rapid-PVST?
A. learning
B. listening
C. discarding
D. forwarding
Answer: C
Section: Chapter 9: Switching
Explanation/Reference:
QUESTION 69
What speeds must be disabled in a mixed 802.11b/g WLAN to allow only 802.11g clients to connect?
A. | 6, 9, 12, 18 |
B. | 1, 2, 5.5, 6 |
C. | 5.5, 6, 9, 11 |
D. | 1, 2, 5.5, 11 |
Answer: D
Section: Chapter 11: Wireless
Explanation/Reference:
QUESTION 70
Refer to the exhibit. Which VLSM mask will allow for the appropriate number of host addresses for Network A?
A. /25
B. /26
C. /27
D. /28
Answer: A
Section: Chapter 3: IP Addressing and VLSM
Explanation/Reference:
0 Response to "12"
Post a Comment