17
QUESTION 13
What are two advantages of Layer 2 Ethernet switches over hubs? (Choose two.) A. decreasing the number of collision domains
B. filtering frames based on MAC addresses C. allowing simultaneous frame transmissions D. increasing the size of broadcast domains
E. increasing the maximum length of UTP cabling between devices
Answer: BC
Section: Chapter 1: Introduction
Explanation/Reference:
QUESTION 14
Refer to the exhibit. A network associate needs to configure the switches and router in the graphic so that the hosts in VLAN3 and VLAN4 can communicate with the enterprise server in VLAN2. Which two Ethernet segments would need to be configured as trunk links? (Choose two.)
A. A B. B C. C D. D E. E F. F
Answer: CF
Section: Chapter 10: VLAN
Explanation/Reference:
QUESTION 15
Which two values are used by Spanning Tree Protocol to elect a root bridge? (Choose two.)
A. amount of RAM B. bridge priority
C. IOS version
D. IP address
E. MAC address
F. speed of the links
Answer: BE
Section: Chapter 9: Switching
Explanation/Reference:
QUESTION 16
Refer to the exhibit. Assume that the routing protocol referenced in each choice below is configured with its default settings and the given routing protocol is running on all the routers. Which two conditional statements accurately state the path that will be chosen between networks 10.1.0.0 and 10.3.2.0 for the routing protocol mentioned? (Choose two.)
A. If OSPF is the routing protocol, the path will be from R1 to R3 to R4 to R5. B. If OSPF is the routing protocol, the path will be from R1 to R2 to R5.
C. If OSPF is the routing protocol, the path will be from R1 to R5.
D. If RIPv2 is the routing protocol, the path will be from R1 to R3 to R4 to R5. E. If RIPv2 is the routing protocol, the path will be from R1 to R5.
Answer: AE
Section: Chapter 6: IP Routing
QUESTION 17
Refer to the exhibit. A network administrator is adding two new hosts to SwitchA. Which three values could be used for the configuration of these hosts? (Choose three.)
A. host A IP address: 192.168.1.79
B. host A IP address: 192.168.1.64
C. host A default gateway: 192.168.1.78
D. host B IP address: 192.168.1.128
E. host B default gateway: 192.168.1.129
F. host B IP address: 192.168.1.190
Answer: ACF
Section: Chapter 10: VLAN
Explanation/Reference:
QUESTION 18
A network administrator changes the configuration register to 0x2142 and reboots the router. What are two results of making this change? (Choose two.)
A. The IOS image will be ignored.
B. The router will prompt to enter initial configuration mode. C. The router will boot to ROM.
D. Any configuration entries in NVRAM will be ignored. E. The configuration in flash memory will be booted.
Answer: BD
Section: Chapter 5: Managing Cisco IOS
Explanation/Reference:
QUESTION 19
Refer to the exhibit. The networks connected to router R2 have been summarized as a 192.168.176.0/21 route and sent to R1. Which two packet destination addresses will R1 forward to R2? (Choose two.)
A. | 192.168.194.160 |
B. | 192.168.183.41 |
C. | 192.168.159.2 |
D. | 192.168.183.255 |
E. | 192.168.179.4 |
F. | 192.168.184.45 |
Answer: BE
Section: Chapter 6: IP Routing
Explanation/Reference:
0 Response to "17"
Post a Comment